Cobalt Digital COMPASS 9391 3G_HD_SD-SDI Timecode Burn-In Inserter - Manual (Page 34)

3
9391 Function Submenu List and Descriptions
3-10 9391-TCB PRODUCT MANUAL 9391-TCB-OM (V1.3)
Provides controls to enable/disable timecode and text
burn-in, and also size and position the burn-ins.
• Timecode Burn-In Enable/Format Select Display control selects from the following modes:
• Disabled never inserts timecode burn-in on video.
• Seconds inserts burn-in timecode in hr:min:sec format.
• Seconds+Frame inserts burn-in timecode in hr:min:sec:frame format.
• Seconds+Frame+Field inserts burn-in timecode in
hr:min:sec:frame:field format.
Note: • Timecode insertion control burns-in timecode as set here on
received SDI video or manual/failover flat field.
• On progressive video where frame count exceeding 30 fps, the field
counter is utilized to show extended frame count as follows:
0.0 Frame 0
0.1 Frame 1
1.0 Frame 2
1.1 Frame 3
...
29.1 Frame 59
• Timecode Size/Position Controls Allows timecode burn-in size/position attributes control as follows:
• Horizontal Size sets horizontal size (in units of 11 lines x control setting;
e.g., control set for “4” results in horizontal size of 4 x 11 = 44).
(Range is 0 thru 15)
• Vertical Size sets vertical size (in units of 11 lines x control setting; e.g.,
control set for “4” results in horizontal size of 4 x 11 = 44).
(Range is 0 thru 15)
• Horizontal Position sets horizontal position (in percentage of offset from
left of image area, left justified).
(Range is 0 thru 100)
• Vertical Position sets vertical position (in percentage of offset from top of
image area, top justified).
(Range is 0 thru 100)
• Identification Text Burn-In Insertion Controls identification text insertion as follows:
• Display enables or disables text burn-in insertion.
• Burn Text dialog entry allows up to 16 ASCII characters to be entered as a
burn-in text string. Upper and lower case characters, as well as numeric
characters, can be entered.
Note: Ident Burn insertion control burns-in text as set here on received SDI
video or manual/failover flat field.
• Identification Text Size/Position Controls Allows text burn-in size/position attributes control as follows:
• Horizontal Size sets horizontal size (in units of 11 lines x control setting;
e.g., control set for “4” results in horizontal size of 4 x 11 = 44).
(Range is 0 thru 15)
• Vertical Size sets vertical size (in units of 11 lines x control setting; e.g.,
control set for “4” results in horizontal size of 4 x 11 = 44).
(Range is 0 thru 15)
• Horizontal Position sets horizontal position (in percentage of offset from
left of image area, left justified).
(Range is 0 thru 100)
• Vertical Position sets vertical position (in percentage of offset from top of
image area, top justified).
(Range is 0 thru 100)
Table 3-1 9391 Function Submenu List — continued