Cobalt Digital COMPASS 9391 3G_HD_SD-SDI Timecode Burn-In Inserter - Manual (Page 13)

9391-TCB-OM (V1.3) 9391-TCB PRODUCT MANUAL 1-9
Introduction
9391 Functional Description
User Control Interface
Figure 1-3 shows the user control interface options for the 9391. These
interfaces are individually described below.
Note: All user control interfaces described here are cross-compatible and can oper-
ate together as desired. Where applicable, any control setting change made
using a particular user interface is reflected on any other connected interface.
Figure 1-3 9391 User Control Interface
Computer
with NIC
OGCP-9000 Control Panel
or
OGCP-9000/CC Control Panel
20-Slot Frame with Network Controller card
LAN
In conjunction with a frame equipped
with a Network Controller card, 9391
card can be remotely controlled over
a LAN
Remote Control Panel
Using the Control Panel, 9391
card can be remotely controlled
over a LAN
DashBoard™ Remote Control
Using a computer with
DashBoard™ installed, 9391
card can be remotely controlled
over a LAN
Note: • To communicate with DashBoard™ or a Remote Control Panel, the frame must have a Network
Controller card installed.
• DashBoard™ and the Remote Control Panels provide network control of the 9391 as shown. The
value displayed at any time on the card, or via DashBoard™ or a Control Panel is the actual value
as set on the card, with the current value displayed being the actual value as effected by the card.
Parameter changes made by any of these means are universally accepted by the card (for
example, a change made using DashBoard™ controls will change the setting displayed on both
DashBoard™ and a Control Panel; a change made using a Control Panel will similarly change the
setting displayed on the Control Panel and DashBoard™).