Cobalt Digital COMPASS 9215-EO-EM AES_EBU Fiber Audio Embedder - Manual (Page 44)

4-16 •••• Menus 9215-EO-EM User Manual •••• (V 1.1)
Menu
Select
Card-Edge Menu
Label
Menu Name
Card-Edge
Item Label
Item Name
G1C1-G4C4
Group 1, Channel 1 to Group 4,
Channel 4
C Ch2 Bkp Channel 2 Backup Source Same as above
D Ch3 Bkp Channel 3 Backup Source Same as above
E Ch4 Bkp Channel 4 Backup Source Same as above
Menu Descriptions
This section briefly summarizes the menu parameters available in the card-edge display of the 9215-
EO-EM.
0 — Home
This read-only menu displays the product name and the slot the card is installed in the frame.
1 — Factory Defaults
This function enables you to return all controls to their factory default values.
Use the following procedure to reset the card parameters to factory default values using the card-edge
controls:
1. Rotate SW1 to 1 . The Four Character Display displays “Fact Def”.
2. Toggle SW2 down and hold for 3 seconds.
3. Release SW2 .
This completes the procedure to reset the card parameters to factory default values.
2 — Reference Source
This menu enables you to select where the card will look for a reference. The choices are Frame
Reference 1 (Fr 1), Frame Reference 2 (Fr 2), and Video (Vid). Refer to the section “Reference
Compatibility” for details.
3 — Loss of Input
Use this menu to select what type of video displays at the system’s outputs when the input video signal
is lost or invalid.
4 — Test Pattern
This menu enables you to specify the type of test pattern to output. Note that this setting is not retained
on power down.
5 — Group Select
This menu enables you to select the embedded group before assigning sources to the channels, enabling
the group, and selecting backup sources. This menu is used in conjunction with Menus 6 to E.