Power led conditions, Bootload button – Cobalt Digital COMPASS 9232 Utility Analog Video Distribution Amplifier User Manual
Page 23

9232 Owner’s Manual (V 1.1)
23
Power LED Conditions
The top front edge of the module has a Power LED which indicates card status. The Power LED
displays the following conditions:
•
Off
no power to the card.
•
Amber
the card is running internal diagnostics while powering up.
•
Green
normal operation.
•
Flashing Green
the card is waiting for a software upgrade.
•
Red
solid or flashing means the card is not operational. Reseat card in frame, check
the Rear Module type and connections, or call Cobalt Digital Technical Support.
Bootload Button
In the unlikely event of a complete card failure, you may be instructed by a Cobalt Digital Technical
Support specialist to perform a complete software reload on the
9232
. Contact Cobalt Digital Technical
Support for the latest software load for your card.
Use the following procedure to perform a complete software reload on the card:
1.
Eject the card.
2.
Press and hold the
Bootload
button, while re-inserting the card into the frame.
3.
Release the button.
The PWR LED will flash GREEN while the card is waiting for a new software load.
If a new software load is not sent to the card within 60 seconds, the card will attempt to
restart with its last operational software load.
This completes the procedure for performing a complete software reload on the card.