beautypg.com

Rear module installation (optional) – Cobalt Digital COMPASS 9232 Utility Analog Video Distribution Amplifier User Manual

Page 11

background image

9232 Owner’s Manual (V 1.1)

11

Rear Module Installation (Optional)

The 9232 is compatible with the 8320 (or equivalent 20-slot) series frames. The procedure for
installing the Rear Module in your frame is the same regardless of the frame or module used. However,
a different module is required depending on the frame you are using.

Installing the Rear Module

If you received a Rear Module with your 9232, you will need to install the module in your frame before
you can install the 9232 in the frame, or connect cables to the slot you have chosen for the 9232. Skip
this section if you are installing the 9232 in a frame where the Rear Module is already installed.

Use the following procedure to install the Rear Module in a frame:

1.

Refer to the frame Owner’s Manual, to ensure that the frame is properly installed
according to instructions.

2.

On the rear of the frame, locate the card frame slot.

3.

Remove the Blank Plate from the rear of the slot you have chosen for the 9232
installation. If there is no Blank Plate installed, proceed to the next step.

4.

As shown in Figure 3, seat the bottom of the rear module in the seating slot at the
base of the frame’s back plane.

Figure 3. Rear Module Installation