Cobalt Digital COMPASS 9232 Utility Analog Video Distribution Amplifier - Manual (Page 15)

9232 Owner’s Manual (V 1.1) 15
Jumper Locations
The following sections describe the jumpers on the 9232.
Figure 6. Jumper Locations
JP1 — Local Termination Jumper
The position of JP2 selects an optional 75ohm termination on the input of the 9232 card.
Select one of the following options:
•
TERM — Install the jumper in this position to terminate the input signal on this
card. This is the default setting.
•
LOOP — Install the jumper in this position to leave the input unterminated. For
example, configure this setting if you wish to loop the signal to another device.
RV2 — Gain Adjustment
The rotation of RV2 adjusts the Gain level of the 9232 and provides a gain range of +/- 3dB.
LEDs
The following sections describe the 9232 LEDs. Refer to Figure 8 for LED locations.