Moog Music MF-107 FreqBox - Manual (Page 6)

6
BASIC APPLICATIONS
The following are diagrams of basic settings of the FreqBox.
They are good staring points for learning how to use the FreqBox. For
each setup, set the knobs on your FreqBox to the position shown. Adjust
the Drive and Output Level controls to match your input signal. Make
sure the Bypass LED is GREEN to hear the effect.
Basic Sync Setup:
This setup is best used
with an expression pedal
plugged into the Freq. input
and clean, single note lines.
The expression pedal can be
used to sweep the frequency
of the VCO slowly for slow
harmonic sweeps, or quickly
and rhythmically for an effect
reminiscent of a wah wah.
Note that with the expression
pedal in the heel position,
notes above a low A on a
guitar are choked out. Use
the expression pedal to keep
the VCO frequency above the
note that you are playing. This
is the basic setup for a classic
hard sync sound.
Figure 3 - Basic Sync Setup