Grain Systems Unload Augers PNEG-1735 - Manual (Page 17)

4. Installation
PNEG-1735 U-Trough Direct Gear Drive Bin Sweep Auger Unload Systems 17
Figure 4O
1. Adjust gearbox shifter linkage such that when shifting into OFF position, there is some resistance
when the lever overcenters into the OFF position.
2. Do not over tighten as this can damage the gearbox.
3. Before operating ensure that the gearbox is shifting properly.
4. Shift into OFF, turn unload flight by hand.
5. The top gearbox should not be turning.
6. Shift into ON position, top gearbox should turn when unload flight is turned.
Figure 4P Gearbox Shifter in ON Position Figure 4Q Gearbox Shifter in OFF Position
Adjust shifter linkage