beautypg.com

Installing the roof flashing – Grain Systems Tanks PNEG-4078 User Manual

Page 109

background image

Chapter 7: Roof Assembly

Installing the Roof Flashing

The roof flashing will seal the area between the center collar and the roof panels.

What You Should Know
Each roof flashing section overlaps and bolts together with the previously installed roof flashing section.

1. Install the first roof flashing section (A) onto the roof panel, and align the holes on the roof flashing

with the roof panel.

2. Install flange bolts (B) and flange nuts (C), securing the first roof flashing section (A) to the roof panel

ribs.

NOTE: Only the first roof flashing section is installed using only six of the required flange bolts and

nuts. Any remaining unfilled holes will be filled when the last roof flashing section is installed.

Figure 7-31 Installation of the first roof flashing section

A

Roof flashing (CTR-0269)

C

5/16 in. flange nut (S-3611)

B

5/16-18 x 1 flange bolt with sealing washer
(S-10260)

Pneg-4078 78 Ft Diameter 40-Series Bin

109