Grain Systems Tanks PNEG-4090 - Manual (Page 95)

Chapter 7: Roof Assembly
A Left-hand lower roof rafter (CTR-0011) H Purlin (CTR-0006)
B 1/2 x 1-3/4 in. flange bolt (S-10252) I 1/2 in. flange nut (S-10253)
C Right-hand lower roof rafter (CTR-0011) J Top X-brace (CTR-0041)
D Right purlin clip (CTR-0100) K Bottom X-brace (CTR-0041)
E Left purlin clip (CTR-0099) L 1/2 x 1-3/4 in. flange bolt (S-10252)
F 1/2 x 1-3/4 in. flange bolt (S-10252) M 1/2 in. flange nut (S-10253)
G 1/2 in. flange nut (S-10253)
Assembling Purlin Number 1
Purlin number 1 is located closest to the eave.
Before You Begin
Place two roof rafters on the ground with roof panel holes facing up. Several A-frame assemblies will have
X-bracing installed and be placed periodically throughout the perimeter of the roof. Determine if X-bracing
is being installed and note those steps in this procedure.
NOTE: Temperature cables may also be installed at this location, to determine if temperature cable brack-
ets will be needed, see About Temperature Cable Brackets and A-Frame Assemblies, page 76 .
What You Should Know
The A-frame assembly consists of two roof rafters identified as the left-hand roof rafter (A) and the right-
hand roof rafter (C). The purlin configuration may not be the same on all A-frames at this location (number
1), depending if X-bracing is being installed or not.
There are also two different purlin clips, a left purlin clip (E) and a right purlin clip (D). The left purlin clip
has seven holes, compared to the right, which has six holes along the purlin and purlin clip mating surface.
IMPORTANT: Do not drill additional holes in purlin. Install the flange bolts and the flange nuts as dictated
by the number of holes in the purlin.
NOTE: The seventh hole located in the center of the left purlin clip (E) is for identification purposes only.
No hardware is used in this location.
1. Attach a right purlin clip (D) and a left purlin clip (E) to the right-hand roof rafter (C), and install two
flange bolts (F) and two flange nuts (I) into the two top holes.
NOTE: If no X-bracing is being installed, install flange bolts (F) and flange nuts (I) in this step.
2. Attach a right purlin clip (D) and a left purlin clip (E) to the left-hand roof rafter (A), and install two
flange bolts (F) and two flange nuts (I) into the two bottom holes.
NOTE: If no X-bracing is being installed, install three flange bolts (F) and three flange nuts (I) in this
step.
3. Install the purlin (H) to the right purlin clip (D) and the left purlin clip (E) located between each roof
rafter. Install eight flange bolts (B) and eight flange nuts (G) securing the purlin to the purlin clips.
NOTE: If no X-bracing is being installed, proceed to step 8.
Pneg-4090 90 Ft Diameter 40-Series Bin 95