Installation – Grain Systems Tanks PNEG-2135 User Manual

Page 69

10. 2.66" Commercial Tank Accessories Installation

PNEG-2135 Construction Manual for 2.66" Corrugation 135' Diameter Tank

Installation

7. If the roof sheet does not have a pre-punched hole for the roof vent, a hole must be cut. Cut the hole

to match the roof vent. The inside edge of the hole should be approximately 15" from the eave.

8. Place the three (3) foam strips on roof sheet, as shown in

. Position roof vent over foam

strips and bolt down using 5/16" x 3/4" bin bolts and nuts. NOTE:

for lower two (2)

bolts of vent.

Figure 10E

Figure 10F

Figure 10G