Grain Systems Tanks PNEG-2135 - Manual (Page 11)

2. Safety
PNEG-2135 Construction Manual for 2.66" Corrugation 135' Diameter Tank 11
General Information
Read this manual carefully. This manual will provide instructions on building the sidewall and stiffeners.
You will also need to consult other instructions in building the tank. These include, but may not be
limited to:
A stiffener and sidewall gauge layout chart. If such a chart is not included with this manual, contact GSI.
Roof instructions must be followed. Roof instructions are included in this manual.
Ladders, roof stairs, roof handrails and other products are covered by separate instruction manuals.
Consult the appropriate accessory manual. Inside ladder instructions are included in this manual.
Aeration systems and transitions are to be installed according to the instructions provided with the system
or transition.
Anchor bolt placement details are provided in the GSI concrete recommendation manual (PNEG-318).
See this manual.
Tools for Construction
1. Combination wrench set 7/16" to 1".
2. Alignment punches 12" long.
3. Hammer.
4. Screwdrivers - standard and philips.
5. 3/8" Drive socket set and ratchet.
6. 1/2" Drive socket set and ratchet.
7. Nail aprons or tool pouches to hold supplies.
8. Gloves for hand protection.
9. Tape measure.
10. 1/2" Drive electric or pneumatic impact gun.
11. 1/2" Drive impact socket set.
12. Lifting jacks.
13. Center pole roof support.
14. Step ladders.
15. Large C-clamp or welding V-grip for clamping.
Quantities required will depend on the number of workers and size of the bin/silo.