Grain Systems PNEG-583 - Manual (Page 4)

4
SEREIS ONE HEATER
The symbol shown is used to call your attention to instructions concerning your personal safety. Watch for this
symbol; it points out important safety precautions. It means "ATTENTION", "WARNING", "CAUTION", and
"DANGER". Read the message and be cautious to the possibility of personal injury or death.
SAFETY ALERT SYMBOL
Thank you for choosing a Neco product. It is designed
to give excellent performance and service for many
years.
This manual describes the operation of the Neco Series
One Centrifugal Heater. It is designed for low to medium
temperature grain conditioning, and is ideal for the aeration
of rice, popcorn or other select grains.
It is available in both propane vapor and natural gas
models.
The principal concern of Neco is your safety and the
safety of others associated with grain handling equipment.
HEATER OPERATION
ROOF WARNING AND DISCLAIMER
Roof Damage Warning And Disclaimer
GSI DOES NOT WARRANT ANY ROOF DAMAGE CAUSED
BY EXCESSIVE VACUUM OR INTERNAL PRESSURE FROM
FANS OR OTHER AIR MOVING SYSTEMS. ADEQUATE VEN-
TILATION AND/OR "MAKEUP AIR" DEVICES SHOULD BE
PROVIDED FOR ALL POWERED AIR HANDLING SYSTEMS.
GSI DOES NOT RECOMMEND THE USE OF DOWNWARD
FLOW SYSTEMS (SUCTION). SEVERE ROOF DAMAGE CAN
RESULT FROM ANY BLOCKAGE OF AIR PASSAGES. RUN-
NING FANS DURING HIGH HUMIDITY/COLD WEATHER
CONDITIONS CAN CAUSE AIR EXHAUST OR INTAKE PORTS
WARNING! BE ALERT!
Personnel operating or working around
electric fans should read this manual.
This manual must be delivered with the
equipment to its owner. Failure to read
this manual and its safety instructions is
As owner and/or operator, it is your responsibility to
know what requirements, hazards and precautions exist,
and to inform all personnel associated with the equip-
ment, or who are in the dryer area. Avoid any alterations
to the equipment. Such alterations may produce a very
dangerous situation, where serious injury or death may
occur.
This manual is written to help you understand safe oper-
ating procedures, and some of the problems that may be
encountered by the operator or other personnel.