Grain Systems PNEG-1856 - Manual (Page 2)

Page 2 of 9 PNEG-1856
Baldor Motor Kit
Programming Baldor H2 and VS Drives on Dryers Built 1993 and
Prior or 1998 and UP (Continued)
All parameters and their settings to be changed for Zimmerman purposes shown in chart below .
NOTE: After programming is complete if local is displayed in upper right hand corner of status screen.
Then Local/Remote button will have to be pressed to change to remote. This is a one time
operation and will not have to be done in the future.
* NOTE: Accutrol Unload Dryers Only - 5 amps is selected for 17' diameter dryers, 6 amps for
23'-4" diameter dryers. Dryers with metering augers stay at factory setting.
Top Level
Programming Menu
1 st Level
Parameter Group
Individual
Parameters
Settings
Zimmerman Changes
Level 1 Blocks Ramp Rates Accel Time #1 3 Seconds
Decel Time #1 3 Seconds
Level 1 Blocks Keypad Setup Stop Key OFF
Stop Mode Coast
Run Forward OFF
Run Reverse OFF
Level 1 Blocks Input Setup Operating Mode Standard Run 3 Wire
Command Source Analog In1
Analog In1 Type Potentiometer
Level 1 Blocks Output Setup Analog Out 1 Type 0-5V
Level 2 Blocks Drive Limits Minimum Output Speed 7 Hertz
Maximum Output Speed 75 Hertz
Level 2 Blocks Drive Protect External Trip ON
Level 2 Blocks Motor Data Motor Rated Amps Factory/5 Amps or 6 Amps*
Press R to Exit Press R to Exit Press R to Exit
Press ENTER at Status