Ladder handrails, Chapter 9 ladder handrails, Handrail gusset and handrail installation – Grain Systems Tanks PNEG-1461 User Manual
Page 52
52
PNEG-1461 12', 15', 18' and 21' Bulk Feed Tank Series and Grain Hopper Tank Series
9. Ladder Handrails
Handrail Installation for Ladder System Without Safety Cage
Handrail Gusset and Handrail Installation
For ladder systems without safety cages, handrails are required. Begin installation by sliding a handrail bar
assembly through the top rung of the sidewall ladder and another handrail bar assembly through the second
rung of the roof ladder as shown in
. All four (4) pieces of LDR-5421, LDR-5414 (2) and LDR-5422
must be assembled as shown in
and installed through
the ladder rungs. The handrail bar assembly pieces will be bolted together when the handrail gussets and
handrails are installed. Position the left hand bottom handrail gusset so that outer most hole lines up with
the outer most hole of the handrail bar assembly. Clamp in place using the wedges, 5/16" x 1" carriage bolt
and 5/16" flange nuts as shown in
. Bolt the handrail gusset to the handrail bar
assembly as shown. Position the left hand top handrail gusset so that the outer most hole lines up with
the outer most hole of the handrail bar assembly. Clamp in place using the wedges and hardware as
shown in
. It will be necessary to loosen the wedge hardware slightly to allow proper
installation of the handrail tubes. Repeat handrail gusset and wedge installation for the opposite side of the
ladder. Install the handrail tubes using the 5/16" hardware as shown in
loosening the
wedge hardware when necessary to obtain the proper fit of the handrail tubes. Tighten all hardware to
complete the assembly.
for detail.
Figure 9A
Failure to follow instructions may cause damage or failure of the equipment.
WARNING
Ref #
Part #
Description
Qty
A
LDR-5421
Handrail Bar Assembly
1
LDR-5414
2
LDR-5422
1
B
LDR-5421
Handrail Bar Assembly
1
LDR-5414
2
LDR-5422
1
C
Roof Ladder
D
Sidewall Ladder