Fig. 1 fig. 2, Fig. 3 – Whirlpool ACM812 User Manual

Page 19

Removing the door

Caution: When carrying out the following operations it is

advisable to wear protective gloves. Carefully follow these

instructions to prevent injury and/or damage to the oven

door and hinges. (Fig. 1)
Pay attention to the oven door hinges: risk of injuring

hands!

Open the oven door

Fully open the saddle brackets

While opening the saddle brackets, use a metal tool such as
handle side of a spoon for easy opening.

Close the door almost completely (Fig. 2), and remove by
pulling it outwards.
NOTE: Proceed in reverse order to refit the door. Make sure the
saddle brackets are lowered before closing the oven door.

Replacing the rear oven lamp:

1. Disconnect the oven from the power supply.
2. After the oven has cooled down, unscrew (anticlockwise)

the lamp cover

A (Fig. 3).

3. Replace the lamp (see note).
4. Refit the lamp cover.
5. Reconnect the oven to the power supply.

Note: Only use 25 W/230 V E-14 type T300°C lamps

available from the After-Sales Service.
Important: Do not use the oven until the lamp cover has

been refitted.

Fig. 1

Fig. 2

saddle
bracket
(see detail A)

saddle
bracket

DETAIL A

Fig. 3