Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner, (325 HP Dodge 5.9L Cummins (24-valve) Trucks) '06-07 Compatible with Optional PowerPDA - Manual (Page 21)

96810 v.7.0
21
center bezel by unclipping the retainer
clips that secure the instrument panel
center bezel to the instrument panel.
Note: the instrument panel center
bezel can be unclipped by prying with
your fingers on a corner. Avoid using
metal tools to pry off the instrument
panel center bezel or cosmetic
damage may occur.
7.
Remove the screws that secure the
instrument cluster bezel then unclip
the instrument center bezel by prying
off with your fingers.
8.
Remove the instrument cluster
bezel and set aside.
9.
Skip to Step 23 to continue.
Alternate Method- Drilling
Instrument Cluster Bezel Using a
Right Angle Drill
Step 10 thru 15.
10.
Remove the screws and unclip
the knee dash panel located under the
steering wheel and set aside.
11.
Remove the (3) screws at the
bottom of the instrument cluster
bezel.
12.
Gently pry on the upper left
corner of the instrument cluster bezel
and unclip the left corner only.
Note: only the left corner of the
instrument cluster bezel will be
unclipped and lifted off the instrument
panel. the right side of the instrument
cluster bezel will be attached with
screws that are not accessible for
removal unless additional steps are
taken to remove them.
13.
Obtain a piece of sheet metal or
similar material.
14.
Place the piece of sheet metal
behind the instrument cluster bezel as
shown in Figure 19.
Figure 19