Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner, (325 HP Dodge 5.9L Cummins (24-valve) Trucks) '06-07 Compatible with Optional PowerPDA - Manual (Page 18)

18
96810 v.7.0
ALTHOUGH THIS CHARGING CABLE
IS SHORT AND ITS CIRCUITRY IS
FUSE-PROTECTED, THE USER IS
ExPECTED TO TAKE APPROPRIATE
MEASURES TO PREVENT SMALL
CHILDREN AND/OR PETS FROM
CONTACT WITH ANY PART OF THIS
SYSTEM.
6.
Re-install the electric connector
bracket that was removed in Section
1, Step 5 below the steering column
in the front of the firewall with the
original two (2) bolts. Route all wiring
away from any pedals or other moving
components. Using the cable ties
supplied, secure the wiring under
the dash. Secure all wiring under the
hood away from heat sources or sharp
edges. Re-install the lower dash panel
with the original 2 screws.
7.
Your Docking Station is now
installed and is ready for the Banks
PowerPDA. Install the Banks PowerPDA
into the Docking Station. Be sure the
Banks PowerPDA is completely seated
in the Docking Station against the
lower support bracket.
8.
Plug the Docking Station’s charging
cable into the charging receptacle
on the lower edge of the Banks
PowerPDA.
Note: there may be a snug fit when
installing the Banks PowerPDA into the
Docking Station. take care not to force
this process.
-Proceed to Section 4.
-END, SECTION 2-