Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Bullet Diesel Tuner '03-07 - Manual (Page 20)

20
96584 v.5.0
Setting Desired Power Level:
To set the desired power level from the
normal display mode, press the ‘MENU’
button until ‘PWR’ is displayed, then
press the ‘SELEcT’ button.
The current power level setting will be
displayed – press the ‘SELEcT’ button to
continue operating at this power level
and return to normal operating mode
(the module will display a ‘SAvED’
message confirming your selection),
or press the ‘MENU’ button to cycle
through power levels ‘STK’ (stock),
‘TOW’ (tow) and ‘SPT’ (sport).
Press ‘SELEcT’ when your desired power
level is displayed, and the Bullet module
will instantly make the necessary
corrections to engine fueling, display
a ‘SAvED’ message confirming your
selection, and return to the normal
display mode. If no buttons are pressed
within five (5) seconds, the module will
return to the standard display mode
without saving any changes.
Quick Power Level Changes:
Power levels can also be quickly
changed at any time from the normal
display mode by pressing the ‘SELEcT’
button. The currently selected power
level will be displayed – pressing the
‘SELEcT’ button again within five (5)
seconds will increase the power level by
one; repeatedly pressing the ‘SELEcT’
button will cycle through power levels
‘STK’-‘SPT’.
Pressing the ‘MENU’ button will set
the currently displayed power level as
the new operating level, and display a
‘SAvED’ message before returning to
the normal display mode. If no buttons
are pressed within five (5) seconds, the
module will return to the standard display
mode without saving any changes.
Setting Desired Maximum
EGT Limit:
To set the desired maximum EGT limit
and alarm level from the normal display
mode, press the ‘MENU’ button until
‘TLMT’ is displayed, then press the
‘SELEcT’ button.
The current EGT limit will be displayed,
in degrees Fahrenheit (the default value
is 900 °F). Press the ‘SELEcT’ button to
continue operating with this EGT limit
and return to normal operating mode
(the module will display a ‘SAvED’
message confirming your selection),
or press the ‘MENU’ button to cycle
through all available EGT limit options
from 800 °F to 1500 °F, in 50 degree
increments.
Press the ‘SELEcT’ button when your
desired maximum EGT limit is displayed,
and the Bullet module will save your
selection, display a ‘SAvED’ message,
and return to the normal display mode.
If no buttons are pressed within five (5)
seconds, the module will return to the
standard display mode without saving
any changes.
The Bullet module will now limit the
measured EGT at or below this value
as much as possible by reducing the
amount of extra fuel that it injects into
the engine. In addition, if the measured
EGT increases 50 degrees past the
selected limit, an alarm will trigger and
illuminate the warning light as well as
flashing the current EGT value on the
display.
WARNING: If the Bullet Diesel Tuner
is installed in tandem, or ‘stacked’
with another performance module
that modifies the amount of fuel
injected into the engine, the Bullet
module may not be able to control
EGT within the set limit as it is not
able to control the functions of the
secondary performance module.