Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Bullet Diesel Tuner '03-07 - Manual (Page 16)

16
96584 v.5.0
control panel should push easily in and
snap back into place – if it does not,
look for kinked or pinched wiring.)
14.
Remove the fuse box cover,
located in the cabin compartment.
Locate mini-fuse #22 and remove.
Install the mini-auto blade fuse tap
onto the removed mini fuse as shown
in Figure 12. Re-install the mini fuse
with the attached blade tap into
location #22 as shown in Figure 13.
15.
Locate the RED single terminal
connector on the Banks harness and
connect it to the mini-fuse blade tap
location #22. Replace the fuse cover
and make sure not to pinch the RED
single terminal wire.
NOTE: Make sure the inline fuse holder
is routed outside the factory fuse box.
16.
Locate the BLAcK ground
wire with the ring terminal on the
Banks Bullet wire harness. Install
ring terminal on top of existing ring
terminals and re-install the screw. See
Figure 14.
17.
Route the 6-pin connector from
the Banks Bullet harness, the 10-pin
connector from the power harness,
and the two-pin connector from the
EGT thermocouple leadwire (if so
equipped) to the back of the Banks
Bullet module and plug them in.
Figure 11
Figure 12: Fuse tap