Banks Power Cummins Motorhomes: (Diesel ’03 - 07 ISB-CR 5.9L) Tuner- EconoMind Diesel Tuner, Class-A w_Allison 3000MH '03-07 Compatible with Optional PowerPDA & Dynafact Gauges User Manual
Page 30
30
96420 v.5.0
The Banks EconoMind Tuner is
equipped with advanced safety
features to preserve your automatic
transmission. One of them is the
capability to detect the occurrence
of transmission slip, and it will
automatically de-rate the engine
output power accordingly.
Before this safety feature can take
effect, the EconoMind Tuner needs to
learn that your coach is equipped with
an automatic transmission.
1.
Go over the entire installation as a
precautionary check to ensure that all
clamps are tight, wiring and hoses are
properly routed, and connections are
tight.
2.
Turn the ignition key to the ON
position. check the EconoMind Tuner
to make sure it’s LED lights are on. The
Tuner and/or PDA will give a warning
initially. Usually, this is an unlearned
transmission warning.
There are troubleshooting procedures
in Section 12.
3.
Start the engine and wait 60
seconds. Listen for any exhaust leaks
or rattles, or intake boost leaks. After
the engine cools, re-tighten clamps
and hoses if leaks are detected.
4.
Put foot on brake and put
transmission into drive. Wait 30
seconds. The error code should clear
after a few minutes.
5.
After completing Step 4, the
transmission should have been
detected by the EconoMind Tuner.
If so, continue to Section 11.
6.
If the error code has not cleared,
then turn off the engine. Recheck all
the connections to make sure they are
fully locked and secure. Repeat Steps
1 through 4.
7.
If the error code still has not
cleared, continue to Step 8.
8.
The following driving test shall be
performed in an area where speeds
over 55mph are safe and traffic is
light.
While driving, listen for any exhaust
leaks or rattles, or intake boost leaks.
After the engine cools, re-tighten
clamps and hoses if leaks are
detected.
9.
carefully bring the coach up to
a speed of 60 MPH without cruise
control and a heavy load. With the
turbo boost below 10psig (i.e., light
load), maintain the attained speed
steadily for at least 30 seconds. Once
the transmission is learned, the “4,3”
diagnostic code will be eliminated
on the Tuner and if installed, on
the optional PowerPDA. Repeat if
necessary to eliminate code. It may
take a few minutes for the code to
clear.
There are troubleshooting procedures
in Section 12.
-END SEcTION 10-
Section 10
Transmission Learning Procedures