Banks Power Cummins Motorhomes: (Diesel ’03 - 07 ISB-CR 5.9L) Tuner- EconoMind Diesel Tuner, Class-A w_Allison 3000MH '03-07 Compatible with Optional PowerPDA & Dynafact Gauges User Manual

Page 28

96420 v.5.0

Locate the universal mount and

docking station in your kit. Interlock

the docking station to the universal

mount by inserting and sliding the

universal mount tabs into the docking

station grooves. See Figure 20.

Find a smooth, flat surface suitable

for ease of access and viewing of the

PowerPDA. Loosen both knobs and

move the swivel suction plate and

docking station to achieve desired

viewing angle of the PowerPDA

screen. Do a test fit and note the

angle necessary to achieve the correct

viewing angle.
Note: There may be a snug fit when

installing the PowerPDA into the

docking station. Take care not to force

this process.

Tighten both knobs to lock in the

position (Figure 20).
Note: If the universal mount swivel

does not move or is tight after

loosening the hold down knob, then

remove the previously inserted

docking station and slightly loosen the

tension screw. See Figure 21.

Locate the alcohol swab in the

kit. clean the suction cup and the

mounting area and let dry. With the

suction lever in the up position ensure

the suction cup is flat against the

windshield or smooth, flat surface.

Then, push the suction lever down to

secure in place.

connect the cab Harness

connector to the PDA cable. Plug the

RJ12 connector (phone like connector

at one end of the PDA cable) into one

of the receptacles in the base of the

PDA docking station.

Install the Banks PowerPDA into

the docking station. Be sure the

PowerPDA is completely seated in

the docking station against the lower

support bracket.
Note: There may be a snug fit when

installing the PowerPDA into the

docking station. Take care not to force

this process.

Plug the docking station’s charging

cable (seen in Figure 20) into the

charging receptacle on the lower edge

of the PowerPDA. Attach the PDA hub

to a smooth, flat surface suitable for

ease of access and viewing.
WARNING: The charging cable on

the docking station is designed

to supply a constant low-voltage

power source (+5vdc) to the

Banks PowerPDA and is “live” as

long as the system’s Diagnostic

Port Cable is completely installed

and the RJ12 connector is

plugged into the docking station.

Although this charging cable is

short and its circuitry is fuse

protected, the user is expected

to take appropriate measures

to prevent small children and/or

pets from contact with any part

of this system.

Route all wiring away from any

pedals or other moving components.

Using the cable ties supplied, secure

the wiring under the dash.

Double check everything to make

sure it is securely fastened and it

is not near any hot or moving parts

before starting engine.

10.

Set up the Banks PowerPDA

according to it’s instructions.

11.

Proceed to Section 10.

WARNING: The PDA may be

susceptible to damage as a

result of extended exposure

to sunlight, heat or extreme

cold. It is highly recommended

that the PDA be removed from

its mounting location if the

vehicle will be subjected to high

concentrations of sunlight, heat

or cold for an extended period

of time. Gale Banks Engineering

is not responsible for damage to

PDA’s resulting from exposure

conditions.

-END SEcTION 9-

Section 9

Mounting the Docking Station and Connecting the

Banks PowerPDA