Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Tuner- Six-Gun Diesel Tuner '99-03 - Manual (Page 19)

96454 v.9.0
19
Press the ‘SELEcT’ button to set the
currently displayed engine parameter
as the default display parameter – the
Six-Gun module will save your selection,
display a ‘SAvED’ message, and return
to the normal display mode where the
parameter you have just selected will
now be displayed on the module. If
no buttons are pressed within five (5)
seconds, the module will return to the
standard display mode without saving
any changes.
Setting the Boost Level
Set Point:
To set the boost level at which the Six-
Gun module will trigger a visual alarm
warning you of a high boost condition,
press the ‘MENU’ button while in the
normal display mode until ‘B SP’ is
displayed, then press the ‘SELEcT’
button.
The current Boost Level Set Point will
be displayed, in PSI (the default value
is 50 PSI). Press the ‘SELEcT’ button
to continue operating with this Boost
Level Set Point and return to normal
operating mode (the module will display
a ‘SAvED’ message confirming your
selection), or press the ‘MENU’ button
to cycle through all available Boost Level
Set Point options from 20 PSI to 50 PSI,
in 1 PSI increments.
Press the ‘SELEcT’ button when
your desired Boost Level Set Point is
displayed, and the Six-Gun module will
save your selection, display a ‘SAvED’
message, and return to the normal
display mode. If no buttons are pressed
within five (5) seconds, the module will
return to the standard display mode
without saving any changes.
Note: In the normal display mode
‘t SP’ (transmission temperature
Set Point) is a non-functioning
setting for this model vehicle.
this menu will still be accessible
and editable, but the settings it
contains will not have any affect
on the Bullet diesel tuner. Please
disregard this setting.
-END, SEcTION 3-