Banks Power Cummins Motorhomes: (Diesel ’93 - 98 B5.9L & C8.3L) PowerPack & Stinger systems w_Twin Ram Manifold 5.9L, 190-210-230-hp rated - Manual (Page 13)

13 p.n. 96385
Figure 10
cpl 1553 – The factory injector lines will be
reused. remove the two line clamp assemblies
from the injector feed lines that are bolted to
brackets. remove the plastic caps from the fuel
pump and the injector nozzles. reinstall the
injector line assembly on the engine using the new
bracket provided as shown in Figure 9. Do not
tighten lines at this time. Torque all fourteen of
the base plate bolts to 18 lb-ft. working from the
center, outward.
cpl‘s 0987 and 1261 – The original factory injector
lines must be replaced. install each of the new
lines in their proper location as shown in Figure
10. install injector line separators as shown. The
6-tube separator is supplied. all others should be
removed from the factory injection lines.
set a heater housing gasket and the rear
heater housing casting in place upon the
manifold baseplate. note that the gasket goes on
one way to match the outline of the baseplate
flange. also note that the rear heater housing has
a machined flat area and two threaded holes in
the front surface of the housing. see Figure 11.
set the other heater housing gasket and front
heater housing in place on the baseplate.
54.
55.