beautypg.com

Velleman HAMGSM133 User Manual

Page 8

background image

HAMGSM133

V. 02 – 15/05/2012

8

©Velleman nv

Note: the caller ID of the used mobile phone must not be hidden (callers’ phone number must be visible when

calling another mobile phone).
At the end of the hold mode the yellow LEDs are switched off and the device waits for a configuration SMS.
With the same phone used to make the first setup call, it is also possible to switch the relay status.

8.2

Through SMS

This mode takes full advantage of the device with operations as output switch, output status query, inclusion of

additional phone numbers to activate the relay, inclusion of numbers for door opening function, reception of

reply messages; change output signals timing and, in general, set the HAMGSM133 with all parameters via

simple SMS. A full reset to restore the default settings can also be made via SMS. See below for the syntax for
all available commands.

8.3

SMS syntax

Commands and settings can be sent from any mobile phone as long as the message includes the
password.

For some commands a password is not required when the message was sent from a telephone number

which is stored in the HAMGSM133. However, some commands that change critical information always
require a password.

The HAMGSM133 replies with a confirmation or information SMS.

Multiple commands can be combined in 1 SMS by placing a comma in between.

Note: commands never contain spaces.

Refer to overview of all configuration SMS commands below.

Change password
Password required
Command PWDxxxxx;pwd

xxxxx = new password (5 digits)

pwd = current password (default = 12345)

Example PWD54321;12345

Store numbers
Password

required for overwrite or from unknown phone

Command NUMx+YYnnnnnnnnnn;pwd

YY = country code

x = position of the number in the list (1~8)

nnnnnnnnnn = phone number (max. 19 digits)

pwd = current password (default = 12345)

Example NUM7+324851234567;12345
Result

Number +324851234567 is stored on location 7 in the master list.

Remove numbers
Password Required
Command NUMx;pwd

x = position of the number in the list (1~8)

pwd = current password (default = 12345)

Example NUM5;12345
Result

The number on location 5 is removed from the master list.

List stored numbers
Password required
Command NUM?;pwd

pwd = current password (default = 12345)

Example NUM?;12345
Result

Show the master list.