Velleman HAMGSM133 - Manual (Page 13)

HAMGSM133
V. 02 – 15/05/2012 13 ©Velleman nv
Request current setting of relay status backup
Password
Command RIP?
Example RIP?
Result
Get an overview of the current setting for the output relay backup.
Start-up SMS content
Password
Command TSU:xxxxxxxx
xxxxxxxx = message (max. 100 characters, all capitals)
Example TSU: SYSTEM START-UP
Result When enabled (see AVVx command), this message is send to phone number
on the first position in the list. Default: SYSTEM STARTUP
Note: a semi colon (;) is not allowed inside the message
Activate start-up SMS
Password
Command AVVx
x = 0 (disabled) or 1 (enabled)
Example AVV1
Result
Enable sending an SMS to the phone number on the first position in the list
when the device is started or restarted. Default: 0 (disabled)
Gate control activation (relay 1)
Password
Command TAC:ss
ss = time in seconds (00~59)
Example TAC:12
Result
When receiving a call from any of the 200 gate control numbers or 8
numbers in the master list, the relay will remain activated for 12 seconds.
Default: 3 seconds
Note: When setting the time to 00, the relay operates in bi-stable mode;
relay 1 will switch status every time the device receives a call.
Store gate control phone numbers (max. 200)
Password required
Command MAC+YYnnnnnnnnnn;pwd
YY= country code
nnnnnnnnnn = phone number (max. 19 digits)
pwd = current password (default = 12345)
Example MAC+324851234567;12345
Note:
There are no specific locations for gate control phone numbers.
Delete gate control phone numbers
Password required
Command DAC+YYnnnnnnnnnn;pwd
YY= country code
nnnnnnnnnn = phone number to delete
pwd = current password (default = 12345)
Example DAC+324851234567;12345
Disable reply SMS
Password
Command RISP
(commands)
Commands: series of commands separated by commas (,)
Example RISP, OUT1:ON, DAC, INI1:10