Velleman HAA2850 - Manual (Page 12)

HAA2850
v4 - 15.11.2013
12
©Ve lleman nv
notifying beep disabled and replaced by 2 short successful
code entry beeps for valid user codes
User code entry mode (only applicable in multi-user mode)
auto entry mode selected; is not required after entering
user code (user codes must have the same length as the
master code)(default for single-user mode)
manual entry mode selected; is required after entering
user code (user codes length can differ from the master
code length) (default for multi-user mode)
Key-press acknowledge tones
key-press tones enabled (default)
key-press tones disabled
Door open time-out
0
no door-open time-out (default)
1 ~ 999
alarm will be triggered when the door remains open
longer than the set time (1~999s)
exit programming mode
information is saved and the keypad returns to normal working mode
Note: in case an error was made during programming, press the button,
or simply wait for 10s and try again.
9. Programming hints
single-user vs. multi-user mode
•
In single-user mode every output can be controlled by only one 4-digit
user code. User codes are stored in memory location and . Default
the -confirmation is not required after entering the user code (auto-
entry mode).
•
In multi-user mode, up to 100 user codes can be assigned to control
output 1 and up to 10 to control output 2. These user codes can consist
of 4 to 8 digits and the -confirmation button must be pressed after
entering the code (manual entry mode). Before setting to auto-entry
mode, all user codes must have the same length as the master code
(between 4 and 8 digits).
Duress code
•
User code 1 in single-user mode and all user codes of group 1 in multi-
user mode come with a duress code function. This duress code is