beautypg.com

Notes, 5 internal switch and terminal, Extension terminal (1) – Velleman CTC1000DS User Manual

Page 8: Jp 2 =internal magnet switch bypass jumper switch

background image

CTC1000DS

V. 01 – 12/06/2013

8

©Velleman nv

1. Open the door contact by loosening the fixing screw.

2. The upper end of the front case has a thinner plastic recess.

Break through the recess creating a hole for the wiring

connection to the extension terminal.

3. Connect the external device(s) to the extension terminal as

shown in the diagram.

Notes
 The extension terminal forms a closed loop with the device

connected to it. when the loop is opened (the device is triggered),
the door contact is activated.

 The device connected to the extension terminal is in series with

the internal magnet switch: both can work together

simultaneously.

 You can choose to use the extension terminal alone with the

internal magnet switch bypassed or to use both together.

 If both the internal magnet switch and extension terminal operate

together, then:
o

When the protected door is opened/closed or the external

device is triggered, the door contact activates and transmits a
signal immediately.

o

However, the door contact will only transmit a (door closed) or

(restored signal) after the protected door and the external
device are restored for 3 seconds.

7.5

Internal switch and terminal

Loosen the bottom fixing screw and remove the cover to reveal
terminal as shown.
Extension Terminal (1)
In addition to the built-in magnet switch, an additional 2-pin dry
contact terminal is provided for an extension magnet switch or any
device with NC (Normally Closed) functionality.
JP 2 =Internal Magnet Switch Bypass Jumper Switch

Jumper ON (jumper link inserted

connecting two pins); the internal
magnet switch will be bypassed. Only

the device connected to extension
terminal will activate the door contact.