Milton CAT D6T - Manual (Page 15)

L-Shaped Push Arms. L-shaped push
arms bring the blade closer to the
machine than diagonal brace designs,
providing excellent maneuverability,
machine balance and blade penetration.
The L-shaped design provides solid
lateral stability throughout the life of the
machine and better cylinder positions
for constant pryout independent of
blade height.
Cutting Edges and End Bits.
High-tensile strength Cat DH-2™ steel
cutting edges resist torsional bending
and distortion in tough applications.
End bits are DH-3 to provide maximum
service life in tough materials.
Load Sensing Hydraulics. Field-proven,
load-sensing, pilot controlled hydraulics
respond to operating requirements by
automatically and continually adjusting
hydraulic power to maximize work tool
efficiency.
Multi-Shank Ripper. The multi-shank
parallelogram style ripper offers the choice
of one, two or three shanks depending
on job conditions. Curved or straight
ripper shanks are available.
Winch. A single lever control actuates
both clutch and brake functions to
improve operator efficiency.
• Input clutches on PTO shaft reduces
engine horsepower losses to
maintain fuel efficiency
• Clutch engagement and brake release
are automatically synchronized for
smoother operation
• Winch components can be serviced
with winch mounted on the tractor
Rear Counterweight. Rear counterweights
may be needed to optimize balance for
backing up steep slopes or increasing
performance in heavy dozing applications.
Rear counterweights are recommended
if another rear attachment is not specified.
Rear counterweights are required with
VPAT blades.
Drawbar. The D6T can be equipped with
a drawbar for retrieving other equipment
or pulling work tools such as:
• Disks
• Compactors
• Chopper wheels
Optional implement towing arrangements
allow for quick setup and use of a
hydraulically controlled towed scraper.
15