Milton CAT D10T - Manual (Page 9)

9
Work Tools
Provide the flexibility to match the machine to the job.
Bulldozers
All blades feature a strong box-section design that resists twisting and cracking. Blades are made
of Cat DH-2™ steel that has high tensile strength and stands up to the most severe applications.
Heavy moldboard construction and hardened bolt-on cutting edges and end bits add strength
and durability.
Semi-Universal Blade – Built for tough applications where penetration is important. •
High-Capacity Universal Blade – Maximizes capacity for moving big loads over long distances. •
Optional Dual Tilt – Allows the operator to optimize the blade pitch angle. •
Cutting Edges and End Bits – Cutting edges are made of DH-2 steel. End bits are made of DH-3 •
steel for maximum service life.
Cat Work Tools offer a range of special application blades.
•
Rippers
Multi-Shank Ripper – Tailors the tractor to the material by using one, two or three shanks. •
Single-Shank Ripper – Operator can adjust the shank depth from the seat using an optional •
single-shank pin puller. Large one-piece shank is available in deep ripping configuration.
Rear Counterweights
Provide proper tractor balance to maximize dozing production. Recommended if not equipped
with any other rear attachment.
Winches
Several options are available. Contact your Cat Dealer.