C&H Technology CM100MXA-24S - Manual (Page 6)

CM100MXA-24S
NX-S Series CIB Module
(3Ø Converter + 3Ø Inverter + Brake)
100 Amperes/1200 Volts
Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 (724) 925-7272 www.pwrx.com
5 05/11 Rev. 2
Electrical Characteristics, T
j
= 25°C unless otherwise specified
Converter Part ConDi
Characteristics Symbol Test Conditions Min. Typ. Max. Units
Repetitive Peak Reverse Current I
RRM
V
R
= V
RRM
, T
j
= 150°C — — 20 mA
Forward Voltage V
F
(Terminal) I
F
= 75A *5 — 1.28 1.8 Volts
NTC Thermistor Part
Characteristics Symbol Test Conditions Min. Typ. Max. Units
Zero Power Resistance R
25
T
C
= 25°C *2 4.85 5.00 5.15 kΩ
Deviation of Resistance ∆R/R T
C
= 100°C *2 , R
100
= 493Ω -7.3 — +7.8 %
B Constant B
(25/50)
Approximate by Equation *6 — 3375 — K
Power Dissipation P
25
T
C
= 25°C *2 — — 10 mW
*2 Case temperature (T C ) and heatsink temperature (T s ) is measured on the surface (mounting side) of the baseplate and the heatsink side just under the chips.
Refer to the figure on page 1 for chip location. The heatsink thermal resistance should be measured just under the chips.
*5 Pulse width and repetition rate should be such as to cause negligible temperature rise.
*6 B (25/50) = In(
R 25
)/(
1
–
1
)
R 50 T 25 T 50
R
25
; Resistance at Absolute Temperature T
25
[K]; T
25
= 25 [°C] + 273.15 = 298.15 [K]
R 50 ; Resistance at Absolute Temperature T 50 [K]; T 50 = 50 [°C] + 273.15 = 323.15 [K]