3 wiring plan, single chamber housing – VEGA VEGASWING 66 - two-wire With SIL qualification User Manual

Page 18

5 Connecting to power supply

VEGASWING 66 • - two-wire

44952-EN-130805

5. Open the terminals with a screwdriver
6. Insert the wire ends into the open terminals according to the wir-

ing plan

7. Tighten the terminals with a screwdriver
8. Check the hold of the wires in the terminals by lightly pulling on

them

9. Tighten the compression nut of the cable entry. The seal ring must

completely encircle the cable

10. Screw the housing cover back on
The electrical connection is hence finished.

5.3 Wiring plan, single chamber housing

The following illustrations apply to the non-Ex as well as to the Ex-d

version.

Fig. 11: Material versions, single chamber housing
1 Plastic (not with Ex d)

2 Aluminium

3 Stainless steel, investment casting

4 Stainless steel, electropolished (not with Ex d)

5 Filter element for pressure compensation or blind plug with version IP 66/

IP 68, 1 bar (not with Ex d)

Housing overview