VEGA VEGABAR 83 4 … 20 mA_HART - Operating Instructions - Manual (Page 46)

46
6 Set up with the display and adjustment module
VEGABAR 83 • 4 … 20 mA/HART
45034-EN-131010
Menu item Parameter Default value
Simulation Process pressure
Reset - Additional settings
Menu item Parameter Default value
PIN 0000
Date/Time Actual date/Actual time
Copy in-
strument
settings
Special pa-
rameters
No reset
Scaling Scaling size Volume in l
Scaling format 0 % corresponds to 0 l
100 % corresponds to 0 l
Current out-
put
Current output - Size Lin. percent - Level
Current output - adjustment 0 … 100 % correspond to
4 … 20 mA
HART mode Address 0
With this function the following device settings are copied.
The following parameters or settings are saved:
•
All parameters of the menu "Setup" and "Display"
•
The menu items "Reset, Date/Time" in the menu "Additional set-
tings"
•
Special parameters
The copied data are permanently saved in the display and adjustment
module. They remain even in case of voltage loss.
Note:
Before the data are stored in the sensor, they are checked to make
sure they match the sensor. For this purpose, the sensor type of the
source data as well as the target sensor are displayed. Storing is only
carried out after release.
In this menu item you gain access to the protected area where
you can enter special parameters. In exceptional cases, individual
parameters can be modified in order to adapt the sensor to special
requirements.
Change the settings of the special parameters only after having con-
tacted our service staff.
Additional adjustments -
Copy instrument settings
Additional adjustments -
Special parameters