VEGA VEGABAR 83 4 … 20 mA_HART - Operating Instructions - Manual (Page 30)

30
5 Connecting to power supply
VEGABAR 83 • 4 … 20 mA/HART
45034-EN-131010
5 1 2 +
( ) (-) 6 7 8
4...20mA
2
3
4
1
Fig. 33: Electronics and connection compartment, single chamber housing
1 Voltage supply/Signal output
2 For display and adjustment module or interface adapter
3 For external display and adjustment unit or Slave sensor
4 Ground terminal for connection of the cable screen
5.10 Switch-on phase
After connecting the instrument to power supply or after a voltage
recurrence, the instrument carries out a self-check for approx. 10 s:
•
Internal check of the electronics
•
Indication of the instrument type, hardware and software version,
measurement loop name on the display or PC
•
Indication of a status message on the display or PC
•
The output signal jumps to the set error current
Then the actual measured value is outputted to the signal cable. The
value takes already carried out settings, e.g. default setting into ac-
count.
Electronics and connec-
tion compartment