VEGA VEGAFLEX 86 4 … 20 mA_HART two-wire Rod and cable probe With SIL qualification - Manual (Page 54)

54
7 Set up with the display and adjustment module
VEGAFLEX 86 • 4 … 20 mA/HART two-wire
44234-EN-130823
To interrupt the function test, you have to push the button "ESC".
If you carry out the function test by means of the "PACTware" soft-
ware, you can store the previously performed tests and continue from
there later on.
In the main menu point "Display", the individual submenu points
should be selected subsequently and provided with the correct
parameters to ensure the optimum adjustment of the display options.
The procedure is described in the following.
The following submenu points are available:
The submenu points described below.
This menu item enables the setting of the requested national lan-
guage.
In the delivery status, the sensor is set to the ordered national lan-
guage.
In this menu item, you define the indication of the measured value
on the display. You can display two different measured values. In this
menu item, you define measured value 1.
The default setting for the displayed value 1 is "Filling height Level".
In this menu item, you define the indication of the measured value
on the display. You can display two different measured values. In this
menu item, you define measured value 2.
The default setting for the displayed value 2 is the electronics tem-
perature.
The optionally integrated background lighting can be adjusted via the
adjustment menu. The function depends on the height of the supply
voltage, see "Technical data".
Display
Display - Menu language
Display - Displayed value
1
Display - Displayed value
2
Display - Backlight