beautypg.com

VEGA VEGAPULS 65 (≥ 2.0.0 - ≥ 4.0.0) Modbus and Levelmaster protocol User Manual

Page 28

background image

28

6 Set up the sensor with the indicating and adjustment module

VEGAPULS 65 • Modbus and Levelmaster protocol

41365-EN-121011

Process/measurement conditions:

– Condensation on the plastic ceiling

– In outside facilities water and snow on the vessel top possible

Transportable plastic tank:

Vessel:

– Material and thickness different

– Measurement through the vessel top

Process/measurement conditions:

– Measured value jump with vessel change

Open water (gauge measurement):

Gauge rate of change: slow gauge change

Process/measurement conditions:

– Distance sensor to water surface to big

– Extreme damping of output signal due to wave generation

– Ice and condensation on the antenna possible

– Spiders and insect nestle in the antennas

– Floating material and animals sporadically on the water surface

Open flume (flow measurement):

Gauge rate of change: slow gauge change

Process/measurement conditions:

– Ice and condensation on the antenna possible

– Spiders and insect nestle in the antennas

– Smooth water surface

– Exact measurement result required

– Distance to the water surface normally relatively high

Rain water overfall (weir):

Gauge rate of change: slow gauge change

Process/measurement conditions:

– Ice and condensation on the antenna possible

– Spiders and insect nestle in the antennas

– Turbulent water surface

– Sensor flooding possible

Demonstration:

Adjustment for all applications which are not typically level meas-

urement

Sensor accepts all measured value changes within the measuring

range immediately

Typical applications:

– Instrument demonstration

– Object recognition/monitoring (additional settings required)

Caution:

If a separation of liquids with different dielectric figure occurs in the

vessel, for example through condensation, the radar sensor can

detect under certain circumstances only the medium with the higher

dielectric figure. Keep in mind that layer interfaces can cause faulty

measurements.