VEGA VEGAPULS 61 (≥ 2.0.0 - ≥ 4.0.0) Profibus PA - Manual (Page 15)

15
4 Mounting
VEGAPULS 61 • Profibus PA
36501-EN-121011
Fig. 5: Flange mounting of the radar sensor
4.3 Mounting preparations, mounting strap
The mounting strap enables simple mounting on the vessel wall or
silo top. It is suitable for wall, ceiling or boom mounting. Especially in
open vessels this is a very easy and effective way to align the sensor
to the bulk solid surface.
The strap is supplied unassembled and must be screwed to the
sensor before setup with three hexagon screws M5 x 10 and spring
washers. Max. torque, see chapter "Technical data". Required tools:
Allen wrench size 4.
There are two ways to screw the strap onto the sensor. Depending
on the selected version, the sensors can be swivelled in the strap as
follows:
•
Single chamber housing
– Angle of inclination 180°, infinitely variable
– Angle of inclination in three steps 0°, 90° and 180°
•
Double chamber housing
– Angle of inclination 90°, infinitely variable
– Angle of inclination in two steps 0° and 90°