beautypg.com

Typical dio 2448 setup – M-AUDIO DIO2448 User Manual

Page 13

background image

13

The middle fader “Wave Output” controls the level of the WAV software
playback, prior to the master volume fader. The rightmost fader “CD
Audio” controls the monitor level of the analog CD-ROM input, again prior
to the master volume fader.

NOTE: If these three controls do not appear in the WSS mixer,
then you must go into the WSS program settings and configure
them properly. To do so, select Options | Properties from the
Volume Control menu. The Properties dialog box will then pop up.
Find the list box at the bottom named “Show the following volume
controls:” and from within this list check only the items ‘Volume
Control’, ‘Wave Output’ and ‘CD Audio’. All other items should not
be checked. Then press OK to return to the mixer page. You
should now see only the three devices.

Typical DiO 2448 Setup

Now that we’ve visited the DiO 2448 Control Panel and WSS mixer, let’s look
at a setup that involves a typical transfer of information from DAT-to-
computer and then computer-to-DAT.

NOTE: Because improper connections can potentially make very
loud noises, it’s a good idea to have monitor levels down while
hooking up audio equipment. You may even choose to have your
computer turned off before making the connections.

In this example, we’ll connect a DAT to the DiO 2448 coaxial S/PDIF input
using a coaxial cable (typically RCA-to-RCA type, 75-ohm impedance).
We’ll also hook the analog outputs of the DiO 2448 to a sound system for
monitoring purposes. A setup like this may be used if you were transferring