VEGA PLICSRADIO R62 Wireless receiving unit - Manual (Page 22)

22
6 Setup with the integrated display and adjustment unit
PLICSRADIO R62 • Wireless receiving unit (multiple channel)
32970-EN-130228
Note:
The configuration of a radio connection is only possible if a PLICSRA-
DIO C62 is connected and ready for operation.
After being switched on, PLICSRADIO R62 first of all carries out a
short self-check. The following steps are carried out:
•
Internal check of the electronics
•
indication of the instrument type, firmware version as well as the
instrument TAG (instrument name)
•
Communication with the connected PLICSRADIO C62
•
Establishment of a radio connection
After switching on, the height of the signal strength is displayed as a
standard. The measured values and measurement loop designations
are only displayed in PLICSRADIO C62.
1. By pushing [OK] you move from the signal strength indication to
the main menu.
2. Select the menu item "Device settings" with [->] and confirm with
[OK].
You can assign an unambiguous name to PLICSRADIO R62 via the
Device-TAG. This function is recommended when several instruments
are implemented and a good documentation of larger systems is
required.
→
Enter the requested values via the appropriate keys and save
your settings with [OK].
The emitting and receiving units must be always set to the same radio
channel. When using several independent radio links, each radio link
must be provided with a different channel. In total, seven radio links
are available (channel 0 … 6).
→
Enter the values via the appropriate keys and save your settings
with [OK].
Switch-on phase
Indication of the signal
strength
Device settings - Device-
TAG
Device settings - Radio
channel