VEGA VEGAFLEX 51K - Manual (Page 21)

VEGAFLEX 51K 21
- +
ESC
OK
Tank 1
m (d)
12.345
Setup
▼
▼
1
5
3
4
2
▼
▼
Adjustment elements
The adjustment module MINICOM is menu-
orientated. The clear text indications on the
display lead through the menu. The functions
of the keys are described in the following.
"OK “ key (4)
With the "OK“ key you can confirm the adjust-
ment.
When the symbol
▼ or is shown in the digital
indication, you can change to a lower menu
level with the "OK“ key.
On the symbol there is no branching point
below the menu item, but only a further menu
item of the respective function.
"ESC “ key (3)
With the "ESC“ key (Escape) you can inter-
rupt an adjustment or a current function or
change to the next higher menu level (de-
pending on the function).
To reach e.g. the uppermost menu level,
push the "ESC“ key several times.
"+ “ and " –“ key (2)
With the "+“ and "–“ keys you can modify the
values of the parameters and choose from a
number of possibilities.
After first pushing, the value to be adjusted
flashes. With any further pushing, the value is
modified.
Arrow keys (5)
With the keys "–>“ and "<–“ you can move
within the menu level from one menu item to
the next.
Digital indication (1)
During operation, the digital display shows
the actual measured value.
When adjusting the instrument, the clear text
display shows the respective function.
▼ Branching point, from where you can
move to the next lower menu.
This symbol informs you about a following
safety inquiry.
Adjustment steps
On the following pages, you will see the menu
schematic of the adjustment module MINI-
COM.
Set up the sensor in the following sequence.
The numbers correspond to the sequence of
the setup. You will find the numbers with the
respective menu points in the menu sche-
matic on the following pages.
1. Adjustment
2. Conditioning
3. Outputs
4. Operating range
5. Measuring conditions
6. Indication of the useful signal and noise
level
▼
▼