Vutec ARTSCREEN Recessed Clip Instructions - Manual (Page 2)

Wood Frame Installation
A typical wood frame including the liner is approximately 5
inches wide to properly cover the assembly. The wood
overhangs the main shell approximately 3/4 inch when
attached.
Two corner woods are attached to the backside of the wood
frame to take-up the weight.
Two spring-loaded catches and a magnetic catch will hold
the wood frame to the main shell. Simply snap the wood
frame to the shell when ready.
Electrical Connections
A duplex AC outlet box is provided for 120VAC connection.
Connect 120VAC to this box to power the TV and the IR
remote control.
The Art Screen comes with IR remote control for
operations. It is ready for use; no wiring connections are
required.
Place the IR sensor so that it can be seen by the transmitter.
Plug the power cord to a 120VAC outlet.
The IR remote control has manual inputs for Home
Automation systems, i.e. AMX, Crestron, etc. See IR
remote control manual (included) for detail information.
The spring-loaded catch (Figure 3b) with SPDT switch may be
used for security purpose; its contacts may be connected to an
audible alarm system or monitoring system. The breach of security
will be activated when the wood frame is removed.
The states of the contacts are shown when the Keeper is not
engaged with the Catch.
Contact Rating: 6Amp, 250VAC or 3Amp, 30VDC.
Figure 3b
Spring-loaded catch with SPDT switch
Figure 4
Side View
Figure 3a
Partial Assembly