VTech DS6670-6C Manual - Manual (Page 6)

Getting started
2
Telephone base and charger installation
Install the telephone base and handset charger(s) as shown below.
Make sure that the electrical outlet is not controlled by a wall switch.
If you subscribe to digital subscriber line (DSL) high-speed Internet service through
your telephone line, you must install a DSL filter between the telephone line cord
and the telephone wall jack. The filter prevents noise and caller ID problems caused
by DSL interference. Contact your DSL service provider for more information about
DSL filters.
Telephone base Handset charger
If you have DSL
high-speed Internet
service, a DSL filter
(not included) is
required.
The DSL filter must
be plugged into the
telephone wall jack.
Electrical outlet not
controlled by a wall
switch
Charger
adapter
Telephone
wall jack
Telephone base
power adapter
Telephone
line cord
Use only the power adapters supplied with this product. To order a replacement,
visit our website at www.vtechphones.com or call 1 (800) 595-9511. In Canada,
go to www.vtechcanada.com or call 1 (800) 267-7377.
The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Even if you do not subscribe to any conventional telephone service, you can still
use the cell line alone without plugging in a telephone line cord.
CAUTION:
If you subscribe to telephone service from a cable company or a VoIP service provider, contact
your cable/VoIP service provider for more information.
•
•
•