VTech DS6672-4 Manual - Manual (Page 89)

Appendix
85
Troubleshooting
If you have difficulty with your telephone, please try the suggestions below.
For customer service, visit our website at www.vtechphones.com or call
1 (800) 595-9511. In Canada, go to www.vtechcanada.com or
dial 1 (800) 267-7377.
I cannot add my cell phone to the telephone base.
Make sure you have cellular coverage.
Make sure your cell phone is compatible with your
DS6671/DS6672. Check the
Bluetooth compatibility list at www.vtechphones.com.
Make sure the Bluetooth function of your cell phone is turned on. See the user’s
manual of your cell phone for more information.
Remove
VTech DS6671/DS6672 from your cell phone’s handsfree device history
list (see the user’s manual of your cell phone for more information).
Carefully follow the pairing instructions on page 24 and make sure that your cell
phone is not connected to any other Bluetooth device.
Turn off your cell phone, then turn it on again.
Reset the telephone base. Unplug the unit’s electrical power. Wait for
approximately 15 seconds, then plug it back in. Repeat the above suggestions.
I cannot connect my cell phone with the telephone base.
Make sure that the Bluetooth function of your cell phone is turned on. See the
user’s manual of your cell phone for more information.
Make sure that your Bluetooth cell phone is not connected to any other
Bluetooth device.
Turn off your cell phone, then turn it on again.
Make sure that your cell phone is connected and active on the cell devices list.
For some cell phones, you must authorize
VTech DS6671/DS6672 device in
your cell phone’s Bluetooth feature. See the user’s manual of your cell phone for
more information.
Manually connect your cell phone to
VTech DS6671/DS6672. Refer to the user’s
manual of your cell phone for more information.
I cannot find VTech DS6671 DS6671/DS6672 on my cell phone. on my cell phone.
Make sure that the telephone base is in discoverable mode. Carefully follow the
setup instructions on page 24.
Make sure that you manually set your cell phone to search for devices.
Remove
VTech DS6671/DS6672 from your cell phone’s handsfree device history
list (see the user’s manual of your cell phone).
Turn off your cell phone, then turn it on again.
Reset the telephone base. Unplug the unit’s electrical power. Wait for
approximately 15 seconds, then plug it back in. Repeat the above suggestions.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•