VTech DS6672-4 Manual - Manual (Page 51)

47
Multiple handset use
PTT to a single handset
You have two ways to begin a PTT call:
If you have two handsets, press and hold PUSH TO TALK
when the handset is not in use.
If you have three or more handsets, press
PUSH TO TALK
when the handset is not in use. Press or to scroll to the
desired handset and then press SELECT or PUSH TO TALK to
create the push-to-talk session, or enter a handset number ( 1-9
for HANDSETS 1-9, and 0 for HANDSET 10,
and 1 for HANDSET 11, and 2 for HANDSET 12).
Your handset displays Connecting to HANDSET X... for a few
seconds. When the connection is made, both the originating and
the destination handsets display Press and hold [PTT] to talk
and beep once.
Press and hold
PUSH TO TALK on your handset. A chirp
indicates your microphone is on. Speak towards the handset.
Your voice is broadcast to the destination handset. While you
are speaking, your handset displays PTT To handset: X
Release PUSH TO TALK after speaking. Both handsets beep
once again. After the handsets beep, you can press and hold
PUSH TO TALK to continue speaking or the destination handset
can respond (see Answer a PTT call on page 49).
Press OFF to end the PTT call. The handset displays Push to talk
Ended for a few seconds.
-OR-
Place the handset in the telephone base or charger to end the PTT call.
After PUSH TO TALK is released, the PTT call remains open for a short time.
If no one presses PUSH TO TALK within 10 seconds, the PTT call
ends automatically.
If PTT is turned off in the destination handset, the originating handset displays
Not available at this time and returns to idle mode.
1.
•
•
2.
3.
4.
•
•
Connecting to
HANDSET X...
Press and hold
[PPT] to talk
Push to talk
Ended
01/02 10:01 AM
PUSH TO TALK
>HANDSET
X