VTech DS6151 Manual - Manual (Page 71)

67
Appendix
Screen display messages (continued)
L1)NO LINE
There is no telephone line connected on line 1.
L2)NO LINE
There is no telephone line connected on line 2.
Line 1 Incoming call
There is an incoming call on line 1.
Line 2 Incoming call
There is an incoming call on line 2.
Microphone ON
MUTE is turned off and the person on the
other end can hear you.
Microphone off
You have turned off the handset microphone.
The other party cannot hear you but you can
hear the other party.
No signal, call ended
Communication between the system handset
and telephone base is lost during a call.
Not available at this time
One system handset or the telephone base is
already viewing the call log or directory and
another handset/telephone base attempts to
review it.
Out of range OR
no power at base
The system handset cannot communicate with
the telephone base. Check the telephone base
power connection or move closer.
Paging all handsets
The telephone base is paging handset(s).
**Paging**
The system handset is paged.
Place handset in charger
The battery is very low. Place the system
handset in the telephone base for recharging.
Ringer muted
The ringer is muted temporarily during an
incoming call.
Saved
Your selection has been saved.
Unable to call try again
You try to make an intercom call but the system
handset/telephone base you are calling is in
the directory, in the call log, on an outside call,
or the system handset is out of range.
Unable to save
You try to save a caller ID entry with no name
or number.