V-Tech DT-TPC Manual - Manual (Page 3)

Item Discription
P201 • Main connection port
LED1
• Power indicator(normally bright)
• Signal indicator(flash)
LED2
• Normal bright when activating divert function
• Flash when the telephone number isn't preset
LED3
• Normal bright when working in Debug mode
(Debug mode:dialing sound can be heard from outdoor
station)
• Flash when working in Test mode
(Test mode:TPC calls a fixed number when divert
function is activated,and the telephone numbers set on
monitor are invalid)
K1
• LED3 will light up when press down the button, and
the Debug mode is activated.
• LED3 will turn off when press down the button
again,and return to Normal mode.
K2
• LED3 will flash when press down the button, and the
Test mode is activated.
• LED3 will turn off when press down the button
again,and return to Normal mode.
SW501 • Refer to 3.2
JW501
• 485 connection port,used to update the software for
TPC
J101 • Connect to the telephone network
J102 • Connect to the telephone
J103 • The same as J101, just terminal is different
J104 • The same as J102, just terminal is defferent
SW401 • Set the configuration,refer to 3.1
2