Veris Technologies Quad 1000 Soil EC Mapping System - Operating Instructions User Manual
Page 41
OM17-Quad1000
6-20
Procedure #9: Removing EC Surveyor Cover: Microchip Replacement and Q1000 to 3150
Resistor Change
It may be necessary to open the EC Surveyor to perform one of the service functions listed below.
Disconnect power cable. Remove four screws in front end plate, and pull end plate slightly to free
up top panel. Be careful not to pull too hard and disconnect any wires.
Figures 9.2 a and b.
Slide top panel out to reveal circuits.
Figure 9.3