Velleman projects K8038 Assembly instructions - Manual (Page 13)

13
SETTING MINIMUM BRIGHTNESS:
• Keep the control button pressed until both LEDs light up (after about 3 seconds) while powering on the
K8038.
• The lamp will now burn at her present minimum brightness
• Change the brightness by pressing the pushbutton briefly and repeatedly (10 steps are available).
• Interrupt the power supply briefly when the desired setting has been obtained.
• Now start the K8038 normally.
Use
The “SER OUT” connector on the print is only used for diagnosis and repair purposes on this kit by the members of our technical department.