Velleman projects K6714-16 Assembly instructions - Manual (Page 10)

10
Connect the phase to “0” and the Neutral to “125” or “220”, depending on the
mains voltage.
Normally the POWER ON LED should be lit now.
In case no manual operation has been provided, you can test the relay by
connecting the inputs (terminals 1 trough 16) to earth (GND) one after another.
Connections possibility's :
1.
Connect the board to the 15 channel receiver K6711 (see Fig. 1.0)
FIG 1.0
17. TEST AND CONNECTIONS :
Test and connections
H67146(16)IP'1_rev1.pub
page 10
Composite
Tuesday, August 25, 2009 12:14