Velleman К8091 User Manual
Page 9
9
construction
2. Power cable
+/- 45cm
• Cut 45cm of the included cable, measured from the female connector.
• Put both cables trough the hole on the rear cover of the housing.
• Strip the male and female cable.
• Connect the female cable/connector to the output connector
SK2, the male cable/connector to output connector SK1
• When both cables have been connected to the K8091EU
mount the strain relief and tighten up with the included 15mm
bolts and M3 nuts.
20mm
7mm
Twist & thin the wires!
L N N L
AC OUT
M3 bolt
Strain relief
M3 lock washer
M3 nut
SK1 SK2
SK1
SK2
See also other documents in the category Velleman Hardware:
- NC3MDL1-B (2 pages)
- NC3MXX (1 page)
- NC5FDL1 (2 pages)
- NC3MDL1 (2 pages)
- EDU01 (32 pages)
- NC5MX (1 page)
- MK166 (1 page)
- К8095 (9 pages)
- VMa02 (4 pages)
- VM8090 (1 page)
- VM116 (32 pages)
- EDU02 (28 pages)
- VM202 (1 page)
- NL4MP (1 page)
- NC3MXX-BAG (1 page)
- VM120 (48 pages)
- VM153 EU (1 page)
- VM119 (32 pages)
- VM133 (24 pages)
- VM148 (24 pages)
- MK155 (1 page)
- VCC6 (20 pages)
- MK179 (2 pages)
- VMa04 (4 pages)
- VM122 (44 pages)
- VM134 (24 pages)
- NAC3FCA (1 page)
- VM121 (32 pages)
- К8048 (14 pages)
- К8048 (15 pages)
- VM150 (1 page)
- VMa01 (4 pages)
- NL4FX (2 pages)
- VM152 (20 pages)
- MK157 (1 page)
- VM112 (4 pages)
- VM130 (20 pages)
- NC3FXX-BAG (1 page)
- MK160 (1 page)
- NC5MDL1 (2 pages)
- VM118r (36 pages)
- VM179 (2 pages)
- VM192ir (2 pages)
- VM138 (40 pages)
- VM160 (20 pages)